Spring clip to suit the 3 badges used on a Datsun 320, "Datsun 1200", "60 HP" and "Datsun D" - Sold individually
Replacement ball joint boot to service the 6 balljoints in the steering linkage and outer tie rod ends
Sold individualy
Sway Bar Bushing Suspension Stabilizer Bar Bushing Kit to suit Datsin 320. Made from polyurethane.
Sold as a set of 2
Rather that write an long winded article. I documented the process of restoring the tail lights on a N320 / U320 / V320 in a handfull of images. The original rubber bulb holders and wiring connectors are usually well past thier useby date so the first part of the project was to work out a solution for the bulb holders. It turns out old Toyota Celicas have just the right sized bulb holder :)
This kit consists of 4 rubber grommets and 1 circlip. There are 3 small grommets used to mount the motor and one large dust shield grommet to go around the drive shaft housing. I have also included a circlip to replace the one-time use circlip that holds the wiper connecting arm onto the crank.
Plastic replacement lids with a modern seal and breather system. Much easier to get off than a rusty original. Sold as a pair, suits both the Brake Master Cylinder and the Clutch Master Cylinder.