Mechanical Parts my be New Old Stock, Reproduction, Refurbished or even used. Please check the advised Condition on each item
This pressure plate suits cars fitted with the column change transmission
This is an aftermarket replacement fuel filter made by RYCO Australia, It comes with a new spring
Complete VRS Gaskey set for the Datsun E1 Engine.
Clutch slave cylinder push rod for column change cars (not sure if it fits the floor change vehicles)
Plastic replacement lids with a modern seal and breather system. Much easier to get off than a rusty original. Sold as a pair, suits both the Brake Master Cylinder and the Clutch Master Cylinder.
This kit consists of 4 rubber grommets and 1 circlip. There are 3 small grommets used to mount the motor and one large dust shield grommet to go around the drive shaft housing. I have also included a circlip to replace the one-time use circlip that holds the wiper connecting arm onto the crank.
Replacement cork and rubber gasket for the glass fuel fiter bowl
Due to the size and cost of this item it wil be delivered using conventional post (no tracking) Price includes postage
Hitachi Type Voltage regulator manufactured by FD Elecman suits a large number of Nissan/Datsun vehicles as listed below
Manifold Gasket to suit the Datsun E1 Engine as used in the Datsun 320 range.
Water Pump Gasket to suit the Datsun E1 Engine as used in Datsun 320 range.
Hot Box Gasket to suit the Datsun E1 Engine as used in Datsun 320. This gasket fits between the inlet manifold and the exhaust manifold
This insulating washer fits between the fuel pump and the engine block to reduce heat transfer from the block into the fuel pump.
This is a second hand item in working order
