Reproduction aluminium body plate, chassis plate or ID plate to suit Datsun 320.
Suits the following vehicles:
Due to the price, shape and weight of these items they will be sent via normal post as a letter. The price shown includes postage via normal postage service
Clutch slave cylinder push rod for column change cars (not sure if it fits the floor change vehicles)
Replacement cork and rubber gasket for the glass fuel fiter bowl
Plastic replacement lids with a modern seal and breather system. Much easier to get off than a rusty original. Sold as a pair, suits both the Brake Master Cylinder and the Clutch Master Cylinder.
This kit consists of 4 rubber grommets and 1 circlip. There are 3 small grommets used to mount the motor and one large dust shield grommet to go around the drive shaft housing. I have also included a circlip to replace the one-time use circlip that holds the wiper connecting arm onto the crank.
These are reproduction front park-turn lens to suit the Datsun 320 and 312 - Only available in clear - Sold as a pair
This is a high quality reproduction badge for the front guards of the Datsun 320 utility, 320 wagon and 320 Dual cab - Sold as a pair
This is a reproduction "Datsun 1200" badge for the front guards of the Datsun 320 utility, 320 wagon and 320 Dual cab - Sold as a Pair
This is a reproduction badge for the bonnet (hood) of the Datsun 320 utility, 320 wagon and 320 Dual cab
Leaf Spring bush for the front mount for the Datsun 320 utility, 320 wagon and 320 Dual cab - Sold as a set of 2
2 x 1/2 inch UNF, zink plated, half lock nuts. One has a left hand tread and the other has a right hand tread.
Reproduction rubber door bumper rubbers that screw onto the "B" pillar - Sold as a pair
This kit consists of one nut (used), one washer (used) and one split pin (new), enough for one side of the car.
This is a second hand item in very good condition
Reproduction lens surround and gaskets to suit square/quadrant shaped lens - Sold as a Kit.
These are reproduction front park-turn lens to suit the Datsun 320 - They are available in both Clear and Amber and only - Sold as a pair.
These are reproduction front park-turn lens to suit the Datsun 320 - They are available in both Clear and Amber and only - Sold as a pair.
These are reproduction interior light lens for the following vehicles. These are for the interior light assemblies that have the external clips to retain the lens
Letter disks to replace the original letter disks in each knob. This is just the Letter "C" for the Choke Knob
Each Disk has an adhesive backing but would benefit from using extra adhesive as the inner of the knob is often rough or has limited contact area
Most knobs have a hole that goes right trough the center allowing the old disks to be removed using a thin punch.
