Letter disks to replace the original letter disks in each knob. This is just the Letter "W" for the Wiper Switch
Each Disk has an adhesive backing but would benefit from using extra adhesive as the inner of the knob is often rough or has limited contact area
Most knobs have a hole that goes right trough the center allowing the old disks to be removed using a thin punch.
Letter disks to replace the original letter disks in each knob. This is just the Letter "L" for the Light Switch
Each Disk has an adhesive backing but would benefit from using extra adhesive as the inner of the knob is often rough or has limited contact area
Most knobs have a hole that goes right trough the center allowing the old disks to be removed using a thin punch.
This is a replacement lens only for the rear reflector. sold as a pair.
Fitting this lens is not an easy task, it will require some patience.
Replacement glass for the Datsun 320 rear view mirror.
Note: These should be glued into place using a neutral cure or non acid cure silicone
Reproduction 3D printed tailgate bumper rubber. These attach to the body with 2 small screws inside the tailgate opening. They are only fitted to the N320 variant
Note: If your located in the USA please contact Moses Thompson directly for these items.
Most of the 320 hinges I've seen have been badly worn. Those that do feel nice and firm have more that likely split the hinge pin into 2 or 3 pieces and that firm action comes from them grinding on the end of the broken pin. New pins are easy to find but getting the old pins out can be very difficult.
Reproduction spear shaped side marker lens only to suit Datsun B10 1000 - Sold as a pair
These are the shorter version of this lens that are approximately 94mm long
EW 7049
This insulating washer fits between the fuel pump and the engine block to reduce heat transfer from the block into the fuel pump.
This is a second hand item in working order