On 13th of Ferurary 2024 my N320 was finally finished to the point it could be registered and driven on the road
These shims come in 3 different thicknesses and are required to set the bearing preload and axle float on the rear axles.
This is a second hand item in good condition
Wheel stud suit both front and rear axles on Datsun 320
This is a second hand item in very good condition
This kit consists of one nut (used), one washer (used) and one split pin (new), enough for one side of the car.
This is a second hand item in very good condition
Second hand fuse block (no cover)
Refurbushed remote starter solenoid to work with either Mitsubishi or Hitachi Bendix style starter motors on early E1 engines.
Letter disks to replace the original letter disks in each knob. This is just the Letter "Cl" for the Cigarette Lighter
Each Disk has an adhesive backing but would benefit from using extra adhesive as the inner of the knob is often rough or has limited contact area
Most knobs have a hole that goes right trough the center allowing the old disks to be removed using a thin punch.
Letter disks to replace the original letter disks in each knob. This is just the Letter "H" for the heater fan switch
Each Disk has an adhesive backing but would benefit from using extra adhesive as the inner of the knob is often rough or has limited contact area
Most knobs have a hole that goes right trough the center allowing the old disks to be removed using a thin punch.
Letter disks to replace the original letter disks in each knob. This is just the Letter "C" for the Choke Knob
Each Disk has an adhesive backing but would benefit from using extra adhesive as the inner of the knob is often rough or has limited contact area
Most knobs have a hole that goes right trough the center allowing the old disks to be removed using a thin punch.
Letter disks to replace the original letter disks in each knob. This is just the Letter "W" for the Wiper Switch
Each Disk has an adhesive backing but would benefit from using extra adhesive as the inner of the knob is often rough or has limited contact area
Most knobs have a hole that goes right trough the center allowing the old disks to be removed using a thin punch.